Craftsman 247.799640 - Manual (Page 12)

CUSTOMER RESPONSIBILITIES
h*
E
a
o
QC
CL
Oil Pivot Points
Clean Chipper-Vacuum V
lU
z
<5
Z
lU
Check Engine Oil
Change Engine Oil V
Service Air Cleaner V
Clean Engine Cylinder V
Spark Plug V
Muffler
V CHECK
GENERAL RECOMMENDATIONS Colder 32“F Warmer
A
WARNING: ALWAYS STOP THE ENGINE
AND DISCONNECT THE SPARK PLUG
WIRE
BEFORE PERFORMING ANY
MAINTENANCE OR ADJUSTMENTS.
5W30 SAE 30
• Periodically check all fasteners and be sure they
are tight
• Follow the Maintenance Schedule above.
CHIPPER-VACUUM
LUBRICATION
Lubricate the pivot points on the height adjustment
mechanism once a season using a light oil.
CLEANING
• Clean the chipper-vacuum thoroughly after each
use.
• Wash the bag periodically with water. Allow to dry
thoroughly in the shade. Do not use heat.
ENGINE
ENGINE OIL
Only use high quality detergent oil rated with API
service classification SF, SG or SH. Select the oil’s
viscosity grade according to your expected operating
temperature.
NOTE; Although multi-viscosity oils (SE30, 10W30,
etc.) improve starting in cold weather, these multi­
viscosity oils will result in increased oil consumption
when used above 32” F. Check your oil ievei more
frequently to avoid possible engine damage from
running low on oil.
Your four-cycle engine will normally consume some
oil—^therefore, check engine oil level regularly approx­
imately every five hours of operation and before each
usage. Stop engine and wait several minutes before
checking oil level. With engine level, the oil must be to
FULL mark on dipstick (refer to figure 10). Change
engine oil after the first five hours of operation, and
every twenty-five hours thereafter.
To Drain Oil:
® Drain oil while engine is warm.
a. Remove oil drain cap. Refer to figure 10. Catch
oil in a suitable container.
b. When engine is drained of all oil, replace drain
cap securely.
® Refill with fresh oil. Refer to GAS AND OIL FILL­
UP section.
* Replace dipstick.
12