Container assembly (see fig. 3), Container mounting (see fig. 4) – Craftsman 917.24985 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3
CONTAINER ASSEMBLY (See Fig. 3)
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top half to
meet bottom half.
3. Press halves tightly together while lifting top to lock
into place as shown.
IMPORTANT:
BEFORE LOG KING THE TABS, HOOKED EDGES
ON BOTH HALVES MUSTOVERLAPTO FORM SEAL AS SHOWN
IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM HALF
CONTAINER
TOP HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
LOCKING
TAB
FIG.3
ASSEMBLY CHECK; Squeeze sides of lower half of con
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
4
CONTAINER MOUNTING (See Fig. 4)
1. Install one container to left side first with warning to
outside of unit. Install another container to center
position and one in right position.
NOTE: Right container should always overlap left container
at center supports.
2. Closecoverand lock latch handles over center support
tubes.