Craftsman 247.28904 - Manual (Page 11)

ASSEMBLY
J
Attaching The Seat
NOTE: If your seat was shipped mounted backwards on the seat pivot
bracket, pull out the tab found on the seat stop and hold it open while
sliding the seat off the seat pivot bracket.
1. Line up the plastic seat spacers with the slots in seat pivot
bracket.
2. Slide seat in until front seat spacer engages the seat stop. See
Fig. 4.
3. To adjust the position of the seat on models equipped with a seat
adjustment lever, move the seat adjustment lever (located under
the seat) to the left and slide the seat forward or rearward until it
securely engages into a seat stop. See Fig. 5. Make sure seat is
locked into position before operating the tractor.
A warning
Tire Pressure
Figure 5
A warning
Maximum tire pressure under any circumstances is 30 psi. Equal
tire pressure should be maintained at all times. Never exceed the
maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
Approximately 10 psi for the rear tires
Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pres­
sure could cause the cutting deck to mow unevenly.
11