Craftsman 315.271220 - Manual (Page 6)

FEATURES
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
WARNING: Carefully read through this entire owner's
manual before using your new drill-driver. Pay close
attention to the Rules For Safe Operation, Warnings
and Cautions. If you use your drill-driver properly and
only for what it is intended, you will enjoy years of safe,
reliable service.
WARNING: Do not allow familiarity with your drill­
driver to make you careless. Remember that a care­
less fraction of a second is sufficient to inflict severe
WRIST STRAP
A wrist strap is provided to reduce the chances of dropping
your drill-driver. Place one hand through the wrist strap
when carrying tool.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the top of the motor
housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top and end of the motor housing.
^ WARNING: If any parts are missing, do not operate
your drill-driver until the missing parts are replaced.
Failure to do so could result in possible serious
injury.
personal injury.
KEYLESS CHUCK PRODUCT SPECIFICATIONS:
Your drill-driver has a keyless chuck that allows you to hand
DRILL-DRIVER 315.271220
tighten or release drill bit in the chuck jaws.
SWITCH
Chuck 3/8 in. Keyless
To turn your drill-driver ON, depress the switch trigger. Motor DC Motor 12 Volt
Release switch trigger to turn your drill-driver OFF.
Gear Train Two Speed
SWITCH LOCK
Switch Variable Speed
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting No Load Speed 0-350 RPM (Low)
when not in use. 0-1100 RPM (High)
VARIABLE SPEED
Clutch 24 Positions
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
Maximum Torque 350 in./lbs.
by the amount of switch trigger depression.
CHARGER ITEM NO. 9-11040
TWO SPEED GEAR TRAIN
Input 120 V, 60 Hz, AC only
Your drill-driver has a two speed gear train designed for
drilling or driving at
HI or LO speeds. A slide switch is Charging Voltage 9.6 - 24 Volt
located on top of your drill to select either HI or LO speed.
Charge Rate 1 Hour
FORWARD/REVERSE SELECTOR
BATTERY PACK ITEM NO. 9-11031
(DIRECTION OF ROTATION SELECTOR)
Your drill-driver has a fonward/reverse selector located
above the switch trigger.