Craftsman 315.115210 - Manual (Page 5)

WARNING; Never use a battery that has been
dropped or received a sharp blow. A damaged battery
is subject to explosion. Properly dispose of a dropped
battery immediately. Failure to heed this warning can
result in serious personal injury.
Before using battety charger, read all Instructions
and cautionary markings In this manual, on battery
charger, and product using battery charger. Fol­
lowing this ruie will reduce the risk of electric shock,
fire, or serious personal injury.
To reduce risk of injury, charge only nickei-cad­
mium type rechargeable batteries. Other types of
batteries may burst causing personal Injury and
damage. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Do not expose charger to wet or damp condi­
tions. Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
Use of an attachment not recommended or sold by
the battery charger manufacturer may result In a
risk of fire, electric shock, or injury to persons. Fol­
lowing this ruie will reduce the risk of electric shock,
fire, or serious personal injury.
To reduce risk of damage to charger body and
cord, puil by charger plug rather than cord when
disconnecting charger. Following this rule will re­
duce the risk of electric shock, fire, or serious per­
sonal injury.
Make sure core! Is located so that It will not be
stepped on, tripped over, or otherwise subjected
to damage or stress. Following this rule will reduce
the risk of serious personal injury.
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock, if
extension cord must be used, make sure:
• That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
• That extension cord is properly wired and in
good electrical condition; and
• That wire size Is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feet) 25‘ 50' 100'
Cord Size (AWG) 16 16 16
Note: AWG = American Wire Gage
Do not operate charger with a damaged cord or
plug. If damaged, have replaced Immediately by a
qualified serviceman. Following this rule will reduce
the risk of electric shock, fire, or serious personal
injury.
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman. Following
this rule will reduce the risk of electric shock, fire, or
serious persona! injury.
Do not disassemble charger; take It to a qualified
serviceman when service or repair is required. In­
correct reassembly may result in a risk of electric
shock or fire. Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
To reduce the risk of electric shock, unplug char­
ger from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Do not use charger outdoors. Following this rule
will reduce the risk of electric shock, fire, or serious
personal injury.
Disconnect charger from power supply when not
in use. Following this rule will reduce the risk of elec­
tric shock, fire, or serious personal injury.
RISK OF g|_gQ-|-RIC SHOCK. DO NOT TOUCH UN­
INSULATED PORTION OF OUTPUT CONNECTOR
OR UNINSULATED BATTERY TERMINAL.
Save these instructions. Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone this tool, ioan them these
instructions also. Following this rule will reduce the
risk of electric shock, fire, or serious personal injury.
A WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities con­
tains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chem­
icals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.