To remove lawn mower from carton, How to set up your lawn, To unfold handle (see fig. 1) – Craftsman 917.372480 User Manual

Page 6: To assemble grass catcher {see fig. 2), Assembly, How to set up your lawn mower

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

Your lawn mower has

been

assembled

the factory

except

for

the grass catcher bag and

the

grass

catcher

frame.

TO REMOVE LAWN MOWER FROM

CARTON

•

Remove loose parts included with

m ower,

• Cut down two end corners of carton and lay end panel

down flat.

• Remove all packing materials except padding between

upper and lower handle

and

padding holding operator

presence control bar to

upper

handle.

• Roll lawn mower

out

of carton and

check

carton thor

oughly

for additional

loose parts.

HOW TO SET UP YOUR LAWN
MOWER

TO UNFOLD HANDLE (See Fig. 1)

•

Raise handles until lower handle section locks into

place in mowing position.

•

Raise upper

handle section into place on lower handle,

remove protective

padding

and tighten both

handle

knobs.

•

Remove handle padding holding operator presence

control bar to upper handle.

•

Your lawn mower

handle

can be adjusted for your

mowing comfort. Refer to

"Adjust

Handle" in the

Service and Adjustment

section

of this manual.

TO ASSEMBLE GRASS CATCHER

{See Fig. 2)

•

Put grass catcher frame into grass bag with stiff part of

bag on the

bottom .

•

Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm

water for a few minutes. If bag gets wet, let it dry before

using.

OPERATOR PRESENCE
CONTROL BAR

UPPER HANDLE

yPTUP

MOWING POSITION

LOWER

HANDLE

FIG. 1

CATCHER FRAME

FRMAE OPENING

FIG. 2