Craftsman 572.61095 - Manual (Page 17)

A WARNING
Do not operate the
flexible shaft with a sharp
bend (A). This can generate excessive heat
and will reduce tool and flex-shaft life. The
recommended minimum is 6" radius (B).
Contents of 53033 Flex-shaft Attachment
Qtv. Description
1 Flex-Shaft Assembly (42" long)
1 Driver Cap
Cutting Guide 53141
The cutting guide (sold separately) comes
completely assembled and ready to use. For
use in a variety of materials up to 3/4" thick.
Match the bit type to the material to be cut.
Always hold the tool firmly, using slow
steady pressure to make cuts.
To attach, follow the four steps shown below.
Important: Always cut in a clockwise
direction, except when following a
template (outlet box), then cut in a
counterclockwise direction.
53134
Drywall Cutting Bit
For use in drywall.
• When inserting the 53134 bit into your
Craftsman Rotary tool, make sure that the
bit has been inserted as far as possible.
• When making freehand cuts in drywall, -
ex., repairing a hole in drywall. When using
a template (outlet box) behind the drywall,
use the Drywall Cutting Bit 53134, cutting
in a counter-clockwise direction.
c T3
' When using 53135, Multipurpose Cutting
Bit, start the bit into the material at a 45
degree angle and then slowly bring it to a
90 degree angle to begin the cut.
53135
Multipurpose Cutting Bit
For use in wood, plastics, drywaii,
fiberglass, vinyl or aluminum siding,
acoustical tile and laminates.
• When inserting the 53135 bit into your
Craftsman Rotary tool, make sure that the
bit has been inserted as far as possible.
• When making freehand cuts in use the
Multipurpose Cutting Bit 53135, cutting in a
clockwise direction.
53136
Tile Cutting Bit (Not Included)
For use on wall tile, cement board and
plaster
• When inserting the 53136 bit into your
Craftsman Rotary tool, it is very important
that 1/16”-1/8” of smooth shank remains
visible above the collet.
• When using 53136, Tile Cutting Bit, start
the bit into the material at a 45 degree
angle and then slowly bring it to a 90
degree angle to begin the cut.
• NOT FOR USE ON FLOOR TILE
17