Craftsman 286.26829 - Manual (Page 18)

OPERATION cont.
ATTACHING REPLACEMENT BLADES TO THE SAW (See Figs. 17 - 20)
A
WARNING:
This Twin Cutter saw uses specially designed eVs-in, blades
and no other types or sizes of blades should ever be used. Other types and sizes
of blades will not operate safely in this saw and could result in serious personal
injury.
See the accessories section of this manual for the proper replacement blades
that are needed for this saw.
1. Unplug the saw.
A
WARNING:
Failure to unplug the saw could result in accidental starting
causing possible serious personal injury.
2. Lay the saw down with the blade arbor pointing upward,
3. Place blade “A" onto ttie blade flange with the "A” clearly visible (see Fig. 17).
4. Align the holes on the blade with the pins on the flange and securely fit the blade
on the flange (see Fig. 18).
5. Take the arbor adapter “1” and push it down onto the flange with the "1" clearly
visible. Make sure that the adapter is properly seated over the flat sides of the
flange.(see Fig. 18}.
6. Place blade “B” onto the adapter with the “B" easily visible, then thread lock nut
onto shaft, DO NOT tighten, (see Fig. 19).
7. Turn the blades so that the holes in both blades are lined up.
Fig. 17
/
..__W /
■ f ■
A
i it
I I
I . . . - u
;
■
\ A '
\
Flange
18