Craftsman 358.795800 - Manual (Page 9)

OPERATION
KNOW YOUR BRUSHWACKER
READ THIS OPERATOR’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Blade
Choke Lever
ON/OFF SWITCH
The ON/OFF SWITCH is used to stop the
engine. Move the switch to the OFF
position to stop the engine.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
Muffler
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the
FULL CHOKE position. After the en­
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le­
ver to the OFF CHOKE position.
BEFORE STARTING ENGINE
ik WARNING; Be sure to read
the fuel information in the safety rules
before you begin. If you do not under­
stand the safety rules, do not attempt
to fuel your unit. Call 1 -800-235-5878.
FUELING ENGINE
A WARNING: Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled en­
gine oil. We recommend Craftsman
brand synthetic oil. Mix gasoline and
oil at a ratio of 40:1, A 40:1 ratio is ob­
tained by mixing 3.2 ounces of oil with
1 gallon of unleaded gasoline. In­
cluded with this brushcutter is a 3.2
ounce container of oil. Pour the entire
contents of this container into 1 gallon
of gasoline to achieve the proper fuel
mixture. DO NOT USE automotive oil or
marine oil. These oils will cause en­
gine damage. When mixing fuel, fol­
low instructions printed on container.
Once oil is added to gasoline, shake
container momentarily to assure that the
fuel is thoroughly mixed. Always read
and follow the safety rules relating to
fuel before fueling your unit.
IMPORTANT
Experience indicates that alcohol
blended fuels (called gasohol or using
ethanol or methanol) can attract mois­
ture which leads to separation and
formation of acids during storage.
Acidic gas can damage the fuel sys­
tem of an engine while in storage.
To avoid engine problems, empty the
fuel system before storage for 30 days