Craftsman 358.745511 - Manual (Page 7)

OPERATING INSTRUCTIONS
it is recommended that the engine
not be operated for longer than 1
minute at full throttle.
OPERATING POSITION
ALWAYS WEAR;
Eye Protection
Long Pants
Heavy Shoes
Cut from your right to your ieft.
WARNING: Always wear eye
protection. Never lean over the trimmer
head. Rocks or debris can ricochet or
be thrown into eyes and face and
cause blindness or other serious injury.
When operating unit> stand as shown
and check for the following:
• Wear eye protection and heavy cloth­
ing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Keep unit beiow waist level.
• Cut only from your right to your left to
ensure debris is thrown away from
you. Without bending over, keep line
near and parallei to the ground and
not crowded into material being cut.
Do not run the engine at a higher
speed than necessary The cutting
line will cut efficiently when the engine
is run at less than full throttle. At lower
speeds, there is less engine noise and
vibration. The cutting line will last
longer and will be less likely to “weld”
onto the spool.
Always release the throttle trigger and
aliow the engine to return to idle
speed when not cutting.
To stop engine:
• Release the throttle trigger.
• Push and release the engine ON/
STOP switch.
TRIMMER LINE ADVANCE
The trimmer line will advance approxi­
mately 2 inches (5 cm) each time the
bottom of the trimmer head is tapped
on the ground with the engine running
at full throttie. The most efficient line
length is the maximum length allowed
by the line limiter.
Always keep the shield in place when
the tool is being operated.
To advance line:
• Operate the engine at full throttle.
• Hold the trimmer head parallel to
and above the grassy area.
• Tap the bottom of the trimmer head
lightly on the ground one time. Ap­
proximately 2 inches (5 cm) of line
will be advanced with each tap.
To advance line, tap bottom of trimmer
head on ground one time.
Line limiter cuts line to '
proper length.
Always tap the trimmer head on a
grassy area. Tapping on surfaces such
as concrete or asphalt can cause ex­
cessive wear to the trimmer head.
If the line is worn down to 2 inches {5
cm) or less, more than one tap will be
required to obtain the most efficient
line length.
A
WARNING: Use only 0.080"
(2 mm) diameter line. Other sizes of
line will not advance properly and can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
CUTTING METHODS
WARNING: Use minimum
speed and do not crowd the line when
cutting around hard objects (rock,
gravel, fence posts, etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
• The tip of the iine does the cutting.
You will achieve the best perform­
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of the Line
Does The Cutting Line Crowded Into
Work Area
.
r.- %
onn ' ■ Wrong
The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it