Nose roller, Video cassette, Keys – Craftsman 917.273322 User Manual
Page 7: Slope sheet, Assembly, Tools required for assembly, To remove tractor from carton, Unpack carton, Unassembled parts
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UNASSEMBLED PARTS
Nose Roller
Nose Roller
^
Brackets
e
( 2 ) Hex Bolts 3/8-16 x 1
(2) Washers
17/32x7/8
X
16Ga.
(2) Nylon Locknuts 3/8-16
Video Cassette
□
Keys
Slope Sheet
m
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness. Review the video cassette before
you begin.
TOOLS REQUIRED FOR
ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(1) Pliers
(1) 1/2" wrench
(
1
) utility knife
(1) 3/4" socket with
drive ratchet
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position (seated behind the steering
wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts boxes from shipping carton.
• Cut, from top to bottom, along lines on
all four corners of shipping carton, and
lay panels flat.
• Remove mower and packing materi
als.
• Check for any additional loose parts or
boxes and remove.