Craftsman 917.270750 - Manual (Page 30)

TROUBLESHOOTING CHART
PROBLEM CAUSE CORRECTION
Poor cut
(cont’d) uneven Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels. Clean around mandrels to
open vent holes.
Mower blades will
not rotate Obstruction in clutch
mechanism.
Worn/damaged mower
drive belt.
Frozen idler pulley.
Frozen blade mandrel.
Remove obstruction.
Replace mower drive belt.
Replace idler pulley.
Replace blade mandrel.
Poor grass dis­
charge
Engine speed too slow.
Travel speed too fast.
Wet grass.
Mower deck not level.
Low/uneven tire air pres­
sure.
Worn, bent or loose blade.
Buildup of grass, leaves
and trash under mower.
Mower drive belt worn.
Blades improperly in­
stalled.
Improper blades used.
Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
Place throttle control in
“FAST position.
Shift to slower speed.
Allow grass to dry before
mowing.
Level mower deck.
Check tires for proper air
pressure.
Replace/sharpen blade.
Tighten blade bolt.
Clean underside of mower
housing.
Replace mower drive belt.
Reinstall blades sharp edge
down.
Replace with blades listed in
this manual.
Clean around mandrels to
open vent holes.
Headlight(s) not
working (if so
equipped)
• Switch is “OFF”.
• Bulb(s) burned out.
• Faulty light switch.
• Loose or damaged wiring.
• Blown fuse.
• Turn switch “ON”.
• Replace bulb(s).
• Check/replace light switch.
• Check wiring and connections,
• Replace fuse.
Battery will not
charge
* Bad battery ceil(s).
• Poor cable connections.
• Faulty regulator (if so
equipped),
* Faulty alternator.
• Replace battery.
• Check/clean all connections.
• Replace regulator.
• Replace alternator.
Engine “backfires”
when turning en­
gine “OFF”
Engine throttle control not
set at “SLOW”
position for 30 seconds
before stopping engine.
Move throttle control to
“SLOW” position and allow
to idle for 30 seconds before
stopping engine.
30