Craftsman 247.796890 - Manual (Page 8)

Lower the leaf ramp by holding the handle and pulling
up on the release bar See figure 12 Leaves and small
twigs can be raked into the chipper-shredder with the
leaf ramp In this position. See figure 13
NOTE
Bulky material, such as stalks or heavy
branches (anything over 1/2" diameter},
should be fed into the chip-it guide,, See
figure 15. Do not force or jam material in­
to the cNp-it guide Make certain leaf
ramp is raised as shown in figure 15 when
using the chip-it guide.
FIGURE 13.
Small branches can also be fed into the leaf ramp See
figure 14.
I WARNING {
'Ф"0 Ф
Make certain chip-it guide door is closed
when not in use
Keep Leaf Ramp Raised
When Using Chip-It Guide
v/iiip-ii Guide
FIGURE 15,