Craftsman 536.772200 - Manual (Page 5)

Insert one end of the control rod from right
to left through the hole in the front wheel
bracket. Attach with hairpin found in parts
bag. See figure below.
air Pin
Front Wheel
Bracket
Push down on handle to tilt unit back.
Insert the other end of the control rod
from right to left through the hole in the
depth control lever. Attach with hairpin
found in parts bag. See figure below.
Depth control lever should be in forward
most selection slot for transport and
starting. See figure below.
Remove bottom packing material.
Hair
To attach the recoil starter rope to the rope
guide, twist the rope through the rope
guide mounted on the right side of the
/ CHECKLIST
Before you operate your new Edger, to
ensure that you receive the best perfor­
mance and satisfaction from this quality
product, please review the following
checklist:
/ Ail assembly instructions have been
completed.
/ No remaining loose parts in carton.
/ All fasteners have been properly
installed and tightened.
While learning how to use your Edger,
pay extra attention to the following impor­
tant items:
// Engine oil is at proper level.
/✓ Fuel tank is filled with fresh, clean,
regular Unleaded gasoline.
// Become familiar with all controls, their
location and function. Operate controls
before starting engine.