Craftsman 486.24608 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

STEP 3:

(SEE FIGURE 4)

• Place plug on a work bench or solid table and push

end of bumper down onto plug. Repeat for remaining
plugs.

STEP 4:

(SEE FIGURE 5)

•

Remove any bolts present In front mounting holes In

side of tractor frame. If bolt will not screw out of hole,
check If a nut Is present on bolt on Inside of frame.
On GT tractors, If access to nut Is blocked by a front
mounted muffler, slide muffler down exhaust tubes to
rest on top of browning shield.

IMPORTANT: Be sure to re-attach muffler and heat
shield after bumper Is Installed.

•

If rear mounting holes In tractor frame are empty.
Install hex bolts and whiziock nuts supplied In the

parts bags. See figure 5.

Call 1 -866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE