Using the clean-out tool (see fig. 15), To move forward and backward (see fig. 16), Power steering operation (see fig. 17) – Craftsman 944.528398 User Manual
Page 12: Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/632039/12/background.png)
OPERATION
USING THE CLEAN-OUT TOOL (See Fig. 15)
In certain snow conditions, the discharge chute may be
come ciogged with ice and snow. Use the ciean-out tooi
to disiodge this biockage.
When cleaning, repairing, or Inspecting, make
certain all controls are disengaged and the au-
ger/lmpellerandall moving parts have stopped.
Disconnect the spark plug wire and keep the
wire away from the spark plug to prevent ac
cidental starting.
•
Release the auger control lever and shut off the engine,
•
Remove the clean-outtool from it's mounting clip. Grasp
the tool firmly by the handle and push and twist the tool
into the discharge chute to dislodge the blockage.
After the packed snow has been dislodged, return the clean
out tool to it's mounting clip by pushing it into the clip,
•
Make sure the discharge chute is pointed in a safe direc
tion (no vehicles, buildings, people, or other objects are
in the direction ofdischarge) before restarting the engine,
•
Restart the engine, then squeeze the auger control
lever to the handle to clear snow from the auger hous
ing and the discharge chute.
TO MOVE FORWARD AND BACKWARD (See Fig. 16)
SELF-PROPELLING, forward and reverse movement of
the snow thrower, is controlled by the traction drive control
lever located on the left side handle,
•
Squeeze traction drive control I ever to handle to engage
the drive system,
•
Release traction drive control lever to stop the forward
or reverse movement of the snow thrower,
SPEED and DIRECTION are controlled by the drive speed
control lever,
•
Press downward on the speed control lever and move
lever to desired position BEFORE engaging the trac
tion drive control lever. Be sure lever springs back and
locks into desired position,
CAUTION: Do not move speed control lever
when traction drive control lever Is engaged.
Damage to the snow thrower can result.
• Slower speeds are for heavier snow and faster speeds
are for light snow and transporting the snow thrower. It
is recommended that you use a slower speed until you
are familiar with the operation of the snow thrower,
NOTE: When both traction drive and auger control levers
are engaged, the traction drive control lever will lock the
auger control lever in the engaged position. This will allow
you to release your right hand from the handle and adjust
the discharge chute direction without interrupting the snow
throwing process.
POWER STEERING OPERATION (See Fig. 17)
Steering triggers are used to assist in steering your
snow thrower. The triggers are located on the underside
of each handle. When a trigger is squeezed, it disen
gages the drive wheel on that side of snow thrower and
allows it to turn in that direction,
•
To turn left - squeeze left side trigger,
•
To turn right - squeeze right side trigger.
12