Switch trigger, Hanging/storage hook, Maintenance – Craftsman 315.114073 User Manual
Page 12: Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
SWITCH TRIGGER
See Figure 4.
To turn the light on and off, depress the switch trigger.
SWITCH
HANGING/STORAGE HOOK
See Figure 5.
On top of the housing is a hook which you can use to
hang the light. This is good for storing the light when not
in use and keeping the light out of the reach of children.
To use, simply lift up on the hook.
HANGING /
STORAGE HOOK
Fig. 4
MAINTENANCE
WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage.
WARNING: Always wear safety goggles or safety
glasses with side shields when using compressed
air to clean workiights. If the operation is dusty, also
wear a dust mask.
ASi
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. Chemi-
cafs can damage, weaken or destroy plastic which
may result in serious personal injury.
Only the parts shown in the parts list are intended to
be repaired or replaced by the customer. Ail other parts
should be replaced at a Sears Service Center.
àk
WARNING: To avoid serious personal injury, always
remove the battery pack from the worklight when
cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
12