Craftsman 315.114073 - Manual (Page 11)

OPERATION
CHARGING A HOT BATTERY PACK
When using the worklight continuously, the batteries in the
battery pack will become hot. You should let a hot bat­
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on Instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE: This situation only occurs when continuous use
of the worklight causes the batteries to become hot. It
does not occur under normal circumstances. Refer to
“CHARGING A COOL BATTERY PACK” for normal
recharging of batteries. If the charger does not charge
your battery pack under normal circumstances, return
both the battery pack and charger to your nearest Sears
Repair Center for electrical check.
TO INSTALUREMOVE BATTERY PACK
See Figure 3.
TO INSTALL:
■ Place the battery pack in your worklight, aligning raised
rib on battery pack with groove in worklight's battery
port.
■ Make sure the latches on each side of the battery pack
snap into place and battery pack is secured to work-
light before beginning operation.
TO REMOVE:
■ Locate latches on side of battery pack and depress
both sides to release battery pack from your
worklight.
■ Remove battery pack from your worklight.
LATCHES
BATTERY PACK Fig. 3
CAUTION: When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
bottom of the drill and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
11