Craftsman 917.270840 - Manual (Page 11)

ASSEMBLE GAUGE WHEELS TO
MOWI^R DECK
The gaiUge wheels are designed to keep
the mower deck in proper position when
operating mower. Be sure they are proper­
ly adjusted to ensure optimum mower per­
formance.
• Assemble gauge wheels with tractor on
a flat level surface.
• Adjust mower to desired cutting height
(See “TO ADJUST MOWER CUTTING
HEIGHT in the Operation section of
this manual).
• With mower in desired height of cut po­
sition, gauge wheels should be assem­
bled so they are slightly off the ground.
Install gauge wheel in appropriate hole
with shoulder bolt, 3/8 washer, and 3/8-
16 locknut and tighten securely.
• Repeat for opposite side installing
gauge wheel in same adjustment hole.
Gauge Wheel
CHECK TIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes.
Correct tire pressure is important for best
cutting performance.
• Reduce tire pressure to PSI shown in
“PRODUCT SPECIFICATIONS” on
page 5 of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be properly leveled. See “TO
LEVEL MOWER HOUSING" in the
Senrice and Adjustments section of this
manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replac­
ing motion and mower blade drive belts in
the Service and Adjustments sectoin of
this manual. Verify that the belts are rout­
ed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your trac­
tor, check to see that the brake is properly
adjusted. See “TO ADJUST BRAKE” in
the Service and Adjustments section of
this manual.
^CHECKLIST
PLEASE REVIEW THE FOLLOWING
CHECKLIST:
✓ All assembly instructions have been
completed.
i/ No remaining loose parts in carton.
✓ Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
✓ Seat is adjusted comfortably and
tightened securely.
✓ All tires are properly inflated. (For
shipping purposes, the tires were
overinflated at the factory).
✓ Be sure mower deck is properly leveled
side-to-side/front-to-rear for best
cutting results. (Tires must be properly
inflated for leveling).
✓ Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
✓ Check wiring. See that all connections
are still secure and wires are properly
clamped.
✓ Before driving tractor, be sure free­
wheel control is in drive position.
WHILE LEARNING HOW TO USE YOUR
TRACTOR, PAY EXTRA ATTENTION TO
THE FOLLOWING IMPORTANT ITEMS:
/ Engine oil is at proper level.
/ Fuel tank is filled with fresh, clean,
regular unleaded gasoline.
/ Become familiar with all controls - their
location and function. Operate them
before you start the engine.
✓ Be sure brake system is in safe operat­
ing condition.
/ It is important to purge the transmis­
sion before operating your tractor for
the first time. Follow proper starting
and transmission purging instructions
(See “TO START ENGINE” and
“PURGE TRANSMISSION” in the Op­
eration section of this manual).
11