Craftsman 973.2748.70 - Manual (Page 8)

OPERATION
SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger. To
turn it OFF, release the switch trigger.
TO INSTALL BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
■ Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 3.
SWITCH LOCK
See Figure 2.
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch
trigger, place the direction of rotation selector in
center position.
A WARNING: Battery tools are always in
operating condition. Therefore, switch should
always be locked when not in use or carrying at
your side.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned, this is a
normal part of the switch function.
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK Fig. 3
■ Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
A CAUTION: When placing battery pack in your
drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components.
TO REMOVE BATTERY PACK
■ Lock switch trigger on your drill by placing the -
direction of rotation selector in center position.
See Figure 2.
■ Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 3.
■ Remove battery pack from your drill.