Assembly – Craftsman 247.38528 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
2.
If satisfied with the height of the handle, tighten the star knobs at
the ends of the lower handle shown in Figure 3. For convenience
of operation, you may adjust the handle height as follows:
NOTE:
Each end of the lower handle must be placed in the same
position on the mounting brackets.
A.
Remove the star knobs shown in Figure 3 and remove the
lower handle.
B.
Position each handle bracket stud into the top hole in the
lower handle.
C.
Tighten the star knobs.
3.
The rope guide is attached to the right side of the upper handle.
See Figure 4. Loosen the wing nut which secures the rope guide.
A.
Hold blade control against upper handle.
B.
Pull starter rope out of the engine. Release blade control.
C.
Slip starter rope into rope guide.
D. Tighten wing nut.
4.
Insert post on cable tie into hole provided on the lower handle.
Pull cable tie tight and trim excess. See Figure 5.