beautypg.com

Storage – Craftsman 917.374356 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

ENGINE

ENGINE SPEED

Your engine speed has been factory set.

Do not attempt to increase engine speed

or it may result in personal injury. If you

believe that engine is running too fast or

too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your
engine does not operate properly due

to suspected carburetor problems, take
your lawn mower to a Sears or other

qualified service center for repair and/or
adjustment.

IMPORTANT:

Never tamper with the

engine governor, which is factory set for
proper engine speed. Overspeeding

the engine above the factory high speed

setting can be dangerous. If you think

the engine-governed high speed needs

adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.

STORAGE

Immediately prepare your lawn mower for storage at the end of the season or if the unit

will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a

period of time, clean it thoroughly, remove

all dirt, grease, leaves, etc. Store in a
clean, dry area.

1. Clean entire lawn mower (See

“CLEANING” in the Maintenance sec­

tion of this manual).

2. Lubricate as shown in the Maintenance

section of this manual.

3. Be sure that all nuts, bolts, screws, and

pins are securely fastened. Inspect
moving parts for damage, breakage

and wear. Replace if necessary.

4. Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

HANDLE

You can fold your handle for storage.

1. Loosen the two (2) handle knobs on

sides of the upper handle and allow

handle to fold down to the rear.

2. Remove the two (2) handle knobs and

carriage bolts on sides ofthe lowerhandle
and pivot entire handle assembly forward
and allow it to rest on mower.

3. Reinstall knobs and carriage bolts to

lower handle / handle brackets for safe
keeping.

• When setting up your handle from

the storage position, lower handle will

require manually locking into mowing
position.

IMPORTANT:

When folding the handle

for storage or transportation, be sure to
fold the handle as shown or you may dam­
age the control cables.

17