Unassembled part, How to set up your tractor – Craftsman 917.273638 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UNASSEMBLED PART
m
J
Your, new tractor has been assembled at the factory. Review the video cassette before
you begin.
When right or left hand is mentioned in this manual,
ating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Cut along dotted lines on all four pan
els of carton. Remove end panels and
lay side panels flat.
2. Remove protective materials from trac
tor hood and grille.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roil off skid.
it means when you are in the oper-
ADJUST SEAT
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service af
ter month and year indicated on label (label
located between terminals) charge battery
for minimum of one hour at 6-10 amps.
(See "BATTERY" in yaintenance section
of this manual for charging instructions).
1. Raise seat and loosen adjustment
knob.
2. Lower seat into operating position and
sit in seat.
3. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
4. Get off seat without moving its ad
justed position.
5. Raise seat and tighten adjustment
knob securely.