Sony CDP-CA8ES - Manual (Page 12)

Playing CDs
'O' You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 5 with
pressing DISC SKIP to check the disc labels. If you close
the disc tray before Step 5, the total playing time appears
in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
'Q' The program remains even after the Program Play
ends
When you press you can play the same program
again.
'Q' The program remains until you erase it
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
plaved in the programmed order.
Note
The total playing time doesn't app>ear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
Checking the track order [j]
You can check your program before or after you start
playing.
Press CHECK on the remote.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
"AL" appears instead of the track number.) After the
last step in the program, the display shows "-END-"
and returns to the original display. If you check the
order after you start playing, the display shows only
the remaining steps.
Changing the track order
You can change your program before you start playing.
To Press
Erase a track [jS CHECK until the track you
don't want appears in the
display, then press CLEAR
Erase the last track in the
program 1 i" : CLEAR. Each time you press
the button, the last track will
be cleared.
Add tracks to the end of the
program DISC 1 - 5 to select the disc,
then number buttons of the
tracks to be added
Change the whole program
completely ■ (stop). Create a new
program following the
programming procedure.
Playing Using a Timer
(CDP-CA9ES only)
You can start playing a disc at any time you want by
connecting a timer (not supplied). Please also refer to
the instructions for the timer if you need help.
TIMER Play mode buttons
1 Press one of the play mode buttons to select the
play mode you want.
2 Set TIMER on the player to PLAY.
3 Set the timer to the time you want.
The player turns off. When the set time comes, the
player turns on and starts playing.
4 After you have used the timer, set TIMER on the
player to OFF.
12