Sony MDP-A500 - Manual (Page 13)

To Play a Disc
This section shows you how to conduct 2 dl the procedures associated with pla)dng both LDs and CDs (CDVs).
How to Load and Play a Disc-
After you have connected the Multi Disc Player to the TV and/or stereo system, you can
begin playing a disc. Locate the POWER, OPEN/CLOSE, and PLAY buttons on the
Remote Commander or the front panel of the player.
1 Turn on the multi disc
player. POWER
POWER
Press POWER on the player or Remote
( ^ Commander.
You can also turn on the player by pressing
(Player) (Remote) OPEN/CLOSE (±) or PLAY (►) on the player.
When using the Remote Commander, press
POWER.
Turn on the TV and stereo
system. TV: Set the input selector on the TV to
"Video".
Stereo System: Turn on the amplifier or
receiver and select CD or AUX for audio
output.
3 Open the disc tray.
9
OPEN/CLOSE
****** OPEN/CLOSE (e).
X———V The front cover of the player slides down and
'—' the disc tray comes out.
(Player) (Remote)
4 Place a disc on the tray Carefully center a single disc on the tray.
If you insert more than one disc, or if the disc is
not seated properly, it may not play or it may
damage the player.
LD (Side A*) When playing a CD, do not use a CD
stabilizer as it may cause damage to
your disc or player.
CD.CDV or LD Single
(Label faces up)
5 Start playback.
PLAY
(Player or Remote)
Press PLAY (►).
The disc tray closes and the disc starts
playing.**
You can also start playing by pressing the disc
tray to close it.
Do not transport the player while
playing a disc as it may cause damage to
the disc
* When playing an LD, the player determines that the upper side of the LD is side “A," and the other side is “B,” regardless of the
label "A" or "B" printed on the disc.
** When playback of the upper side of an LD (side A) ends, the other side (side B) starts playing automatiailly.
To Plav a Disc 13