Sony CDP-CE405 - Manual (Page 19)

Additional Information
Troubleshooting Specifications
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
■♦Check that the player is connected securely.
^Make sure you operate the amplifier correctly.
^Adjust the playback level using the PHONE
'LEVEL control on the player (CDP-CE505 and
CDP-C450Z only) or LINE OUT LEVEL +/- on
the remote (except for CDP-CE305, CDP-C250Z
and CDP-C661).
The CD does not play.
^There's no CD inside the player ("no DISC"
appears). Insert a CD.
^Place the CD with the label side up on the disc
tray correctly.
^Clean the CD (see page 18).
■♦Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
The remote does not function, (except for CDP-CE305,
CDP-C250Z and CDP-C661)
"♦Remove the obstacles in the path of the remote
and the player.
^Point the remote at the remote sensor- H on the
player.
^Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
■♦The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Compact disc player
Laser
Laser output
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Semiconductor laser (k = 780 nm)
Emission duration: continuous
Max 44.6 pW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ± 0.5 dB
CDP-CE505/C450Z: More than 107 dB
CDP-CE405/CE305/C350Z/C250Z
/C661: More than 102 dB
More than 98 dB
CDP-CE505/C450Z: Less than 0.0035%
CDP-CE405/CE305/C350Z/C250Z
/C661: Less than 0.0045%
More than 100 dB
Output
Jack
type Maximum
output
level
Load
impedance
LINE OUT Phono
jacks
2 V
(at 50 kilohms) Over 10 kilohms
DIGITAL OUT
(OPTICAL)
(CDP-CE505/
C450Z only)
Optical
output
connector -18dBm Wave length: 660nm
PHONES
(CDP-CE505/
C450Z only)
Stereo
phone jack 10 mW 32 ohms
General
Power requirements
Where purchased Power requirements
USA 120 VAC, 60 Hz
Australia 240 V AC, 50/60 Hz
Power consumption
Dimensions (approx.)
(w/h/d)
14 W
430
X
120
X
385 mm
(17x4 3/4
X
15 1 /4 in.) inch projecting
parts
Mass (approx.) 5.6 kg (12 lbs 6 oz)
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (except for CDP-CE305,
CDP-C250Z and CDP-C661) (1)
Sony SUM-3 (NS) batteries (except for CDP-CE305, CDP-
C250Z and CDP-C661) (2)
Design and specifications are subject to change without notice. 1 9