Sony KV-32S42 - Manual (Page 10)

W Connecting and Installing the TV (continued)
Cable Box Connections
Some pav cable TV systems use scrambled or
encoded signals that require a cable box to
view all channels.
Cable box
1 Connect the coaxial connector from your
cable to the IN on your cable box.
2 Using a coaxial cable, connect OUT on
your cable box to VHF/UHF on your TV.
If you will be controlling all channel selection
through your cable box. you should consider
using the CHANNEL FIX feature, (see page 23).
Cable
(Rear of TV)
VHF/UHF
T Í
=03—
Cable box and cable
KV-32S66, 35S66 only
For this set up, you can switch between
scrambled channels (through your cable box),
and normal (CATV) channels by pressing
ANT on your remote control.
Notes
• Your Sony remote control can be
programmed to operate your cable box,
(see page 30).
• When using PIP, you cannot view the
AUX input in the window picture.
T i p
P r e s s i n g A N T s w i t c h e s b e t w e e n t h e s e i n p u t s .
If you are connecting a cable box through the AUX input and
would like to switch between the AUX and normal (CATV) input
you should consider using the CHANNEL FIX feature, (see page 23).
(Rear of TV)
AUX
rCD=
TO CONVERTER
75-ohm coaxial cable (not supplied) T (signal)
VHF/UHF
CATV cable (unscrambled channels)