Sony CDP-C225 - Manual (Page 13)

If you program the selections for side B, insert a
pause. . 3 .. lights up.
* f-l F 1
rn •1
•
-«*“ if k S. CC/M
I Total time will return
Pause to “0.00”.
A pause is counted as one programming step.
^ Program the selections for side B.
ff Repeat steps 3 to 4.
8U-
The selections for side A will
start playing.
b
To check your program
To program a whole disc
• Using the DISC 1 to 5 buttons
After steps 1 and 2:
1 Press the DISC 1 to 5 button to select the disc.
2 Go to step 5.
• Using the DISC SKIP button.
After steps 1 and 2:
1 Press DISC SKIP. “AL” is displayed in the window.
2 Press PROGRAM.
3 Go to step 5.
The whole disc is programmed as one step.
To program while observing the disc labels
You can program the selections with the disc compartment
open.
To play the selections for side B
When the selections for side A have been played, the unit
will pause. (“B” lights up.)
Set the tape to the beginning of side B, then press ^ or
II.
The selections for side B will start playing.
To stop program play
Press ■. The last selection number programmed is
displayed.
To resume play, press
>■. Play begins from the beginning
of the program.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playing
mode. The program will be erased.
Skipping to the next selection programmed
Press during play.
Going back to the beginning of the selection being played
Press
during play.
Press CHECK. The first selection in the program will be
displayed when CHECK is pressed during play, the selection
being played is displayed.
Each time you press CHECK, the next selection in the
program will be displayed. When CHECK is pressed after
the last selection, “End” appears and then the display
returns to the initial display.
To change your program
You can make the following changes before starting play.
To erase the last selection, press CLEAR during stop
mode.
Each time you press CLEAR, the last selection in the
program will be erased.
To add a selection to the end of the program, just
press the numeric button for that selection. You can add a
selection also during play or pause.
To delete a selection, press CHECK repeatedly until the
undesired selection is displayed. Then press CLEAR.
To erase the entire program___________________________
Press ■ once during stop; twice during play.
The program win be erased In the following attuadona
• ± is pressed during program play.
• Power is turned off.
To check the step of programmed selections
Press TIME during stop mode.
The number of programmed selections will be displayed for a few
seconds in the window.
To check the remaining time
Press TIME once to see the remaining time of the selection being
played; twice to return to the initial display.
The total remaining time cannot be displayed.
If you have programmed a selection number over 20, numeric of
STEP is displayed instead of the remaining time.
Note
When selections have been programmed for sides A and B, the total
playing time displayed during stop mode will show the selections
programmed for side B and the total playing time for side B.
13