Sony RM-V12 - Manual (Page 4)

TV_________
Cable box
For example, if you're setting up a CD player, you
would press and release 5.
4
Press and release the ENT button
to store the code number in the
Commander's memory.
To finish setting up the component, go to "Step 1;
Entering the Code Number" and complete the
procedures that are described.
Searching for the Correct Code
If you've tried all the code numbers listed for your
component and you still cannot get the Commander to
work, try these steps:
1 Using the component's original remote control (or
the power switch on the component itself), power
on the component.
2
Set the slide switch on the
Remote Commander to the
position of the component that
yoirwant to set up.
3
Press the POWER button while
pressing the SLEEP button.
4
Press and release the CH +
button. Then press and release
the POWER button.
5
Repeat step 4 until your component powers off.
Pressing CH + and POWER repeatedly will try
every available code until the correct one is found.
Be patient as you do this; it may take 50 or 60 tries
until the correct code number is located.
6
When the component powers off, press and
release the ENT button to store the code
number in the Commander's memory.
7
Check that the Commander is
operating the other functions of
your component. Turn on the
component again; then press the
channel and volume control buttons.
If it seems to be working properly, you're done
setting up the Commander.
If you still cannot get the Commander to work
properly, see "Troubleshooting".
Setting Up Video
Components That Are
Connected to an Audio
System
The Remote Commander is factory preset based on the
assumption that you play the audio portion of your
video programs through your TV's speakers, and that
Using the Remote
Commander
Turning On/Off a Component
1 Set the slide switch on the
Remote Commander to the
position of the component that
you want to turn on/off.
2
Point the Commander directly at the component.
3
Press the POWER button to
power on/off the component.
(^ po w er )
Note: There may be cases you may turn on/off the
cable box by pressing the CH+ or CH- buttons on the
Commander.
Operating a Component
1
Make sure the slide switch is set to the component
you want to operate.
2
Point the Commander directly at the component.
3
Press the button for the function you want to use.
See "Remote Button Descriptions" for complete
descriptions of the buttons on the Commander.
Remote Button Descriptions
Remote
Button
Operates Function
( tw v ide ^
TV
VCR
Selects the input mode
(pOWER^
All
components
Turns on and off the
component
o ; : ; ©
©
TV
VCR
Cable box
Selects the channel. For
example, to go to channel
5, press 0 and 5 (or, press 5
and ENT.)
You can also change the
channel with CH -»-/-.
Receiver/amp Selects the input source;
1 selects VIDEOl
2 selects VIDE02
3 selects VIDE03
4 selects TUNER
5 selects CD PLAYER
6 selects TAPE DECK
8 selects TV
9 selects CABLE BOX
(7 and 0 do not have an
assigned function)
CD player Selects the track number. 0
selects track 10.
To select track numbers
above 10, see DISP.