Sony RM-V12 - Manual (Page 2)

Cable box CBL
TV TV
VCR VCR
Receiver/amp, CD player, tape deck. AV
or a second TV, VCR, or cable box
If You Have Sony Components...
You won't need to set up the Commander before you
start using it. (This Commander is preset at the factory
to operate Sony brand components.) However, you will
need to set up the Commander if you have a cable box,
Also, slide switch position AV is factory preset for Sony
receivers. If you want to control different component
with AV, you must first set up the Commander as
described following.
If You Do Not Have Sony
Components...
You'll need to follow the instructions in this manual to
preset the Remote Commander with the correct code
numbers for each of your components.
If You Have Video Components that
Are Connected to an Audio System...
See "Setting Up Video Components That Are
Connected to an Audio System".
Installing the Batteries
Slide open the battery compartment and insert two size
AA batteries (not supplied).
Be sure to line up the O and O on the batteries with the
o and O on the battery compartment.
Notes on Batteries
• Under normal conditions, batteries will last up to six
months. If the Remote Commander does not operate
properly, the batteries might be worn out. When
replacing batteries, replace both of them with new
ones.
• Do not mix old batteries with new ones or mix
different types of batteries together.
Set to AV
E
Continue with
procedures
^33 s) + (POWER^
Enter code for ^ (
component type ^ ^
Component Code
VCR 1
Receiver/amp 4
CD player 5
Tape deck 6
TV 8
Cable box 9
step 1; Entering the Code Number
If you are setting up the Commander to operate
components on position AV, you must first complete
the procedures described under "Before You Set Up
AV,..".
iri'i......... Ü 'iji
Set the slide switch on the
Remote Commander to the
position of the component that
you want to set up.
See "Component Code Numbers", and find the
two-character code number for your component.
If more than one code number is listed, use the
number that's listed first to complete the steps that
follow.
For example, if you're setting up a Philips VCR,
you would use code number 10.
Brand Component Code No.
Philips VCR 10, 08, 09
(POWER^
If your component is not listed, see "Searching for
the Correct Code".
Press the POWER button s le e p
while pressing the SLEEP ^3 s)
button.
Enter the component's code
number.
For example, if you're entering
the code for a Philips VCR, you
would press and release 1, then
press and release 0.
© ©
Your Code
Number
•> Press and release the ENT button
to store the code number in the
Commander's memory.
6
Go to "Step 2: Checking if the Code Number
Works" to finish setting up.