Programming the remote control – Sony DTR-HD1 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Digital Television Receiver
Programming the Remote Control
If you have video components other than a Sony brand that you
would like to control with the DTV Receiver's remote control,
use the following procedures to program the remote control.
^ Your component must have infrared (IR) remote control capability in order to be
used yvith the remote control.
1 Turn to "Programmable Codes" on page 24, and find the
three-digit code number for your component. If more than
one code number is listed, use the number listed first to
complete the following procedures.
Ha You'ihust perform step 3 within 10 seconds of step 2, or you must start
. again from step 2.
2
Press CODE SET.
must perform step 4 within 10 seconds of step 3, or you must start
l^ain from step
2.
To cancel the operation, press the ENTER button.
3 Press the FONQION button for DBS/CABLE, or TV.
4 Enter the three-digit code number.
5
Press ENTER.
To Check if the Code Number Works
Use the following prbcedure to make sure the code you've
entered works:
1 Aim the DTV's remote control at the component and press
the POWER button that corresponds to that component.
2 For TVs and cable boxes: If the component responds, try the
CH+ and CH- buttons. If the component responds, you're
done.
22