Attaching/releasing infant seat, Warning – Combi Flash EX 655 User Manual

Page 6

Attaching/Releasing Infant Seat

- 6 -

Trade name and trademarks of Graco

, Century

, Evenflo

and Cosco

and Peg-Perego are the property of their respective owners and no endorse-

ment of or approval by them is intended or implied. All Combi Flash EX strollers are compatible with specified models of the Graco

, Century

Evenflo

®,

and the Peg-Perego

infant car seat/carrier models

as of the date this printing was prepared.

2. Unbuckle the

attachment
strap and lay
over the right
and left side
of the stroller
frame.

3. Hook the infant

seat onto front
rail of the stroller.
The foot end of
infant car seat/
carrier will rest on
the two L-shaped
brackets.

Cosco, Eddie Bauer,

Evenflo, Discovery, Peg-Perego

1. Use object to press in plastic tabs to release right and left end caps.

(See diagram A)

The plastic tabs are located underneath the front rail

of the stroller on the plastic right and left rail covers.

(See diagram 1)

Right and left end caps will be released by pressing in plastic tabs.

(See diagram B)

End caps must be removed to install Cosco Eddie

Bauer, Evenflo, Discovery or Peg-Perego infant carrier.

Bauer, Evenflo, Discovery or Peg-Perego

WARNING

Never use this product without securing the attachment
strap to the infant seat.

WARNING

The infant harness must be buckled correctly per your
manufacturer's instructions.

Note: Illustrations are for
reference only and may not
represent the actual product.

Remove End Cap

REMOVING THE INFANT SEAT/CARRIER

Remove the infant car seat/carrier by reversing the

above steps. See your infant car seat manufacturer's
instructions for proper release lever operation.

3. Bring the infant seat attachment straps through the

seat belt guides in the infant car seat/carrier and fas-
ten the buckle. To loosen, tilt the buckle and pull up.
To tighen, pull the strap.

WARNING

Make sure you tighten the attachment strap before
usage.