Attaching/releasing infant seat, Warning – Combi Flash EX 655 User Manual

Page 5

- 5 -

Trade name and trademarks of Graco

, Century

, Evenflo

and Cosco

and Peg-Perego are the property of their respective owners and no endorse-

ment of or approval by them is intended or implied. All Combi Flash EX strollers are compatible with specified models of the Graco

, Century

Evenflo

®,

and the Peg-Perego

infant car seat/carrier models

as of the date this printing was prepared.

Attaching/Releasing Infant Seat

1. Unbuckle the attachment strap and lay over the right

and left side of the stroller frame.

2. Hook the infant seat onto front rail of the stroller. The

foot end of infant car seat/carrier will rest on the two
L-shaped brackets.

Remove the infant car seat/carrier by reversing the

above steps. See your infant car seat manufacturer's
instructions for proper release lever operation.

REMOVING THE INFANT SEAT/CARRIER

3. Bring the infant seat attachment straps through the

seat belt guides in the infant car seat/carrier and fas-
ten the buckle. To loosen, tilt the buckle and pull up.
To tighen, pull the strap.

Note: Illustrations are for reference only and may not represent
the actual product.

WARNING

Never use this product without securing the attachment
strap to the infant seat.

WARNING

The infant harness must be buckled correctly per your
manufacturer's instructions.

Combi Tyro, Combi Connection, Graco Snugride, Evenflo.
Portabout, Peg-Perego

WARNING

Make sure you tighten the attachment strap before usage.