Tri-Tronics NightRazor Spotlight - Manual (Page 2)

► The NIGHTRAZOR has LED lights
that indicate battery charge level.
These are visible inside the rim of the
optical lens at about the 10:00 o’clock
position. (Do not shine the light in
your eyes, it is bright!)
► Red flashing LED – Indicates the
light will not work. Turn the intensity
knob to the off position and place the
NIGHTRAZOR on the charger for
a full charge (it takes under 4 hours).
► While charging, the red LED is solid.
The NIGHTRAZOR is fully charged
when the green LED is solid.
► The NIGHTRAZOR has a separate
charging cradle. To purchase additional
accessories, go to www.tritronics.com.
► After the NIGHTRAZOR is fully
charged, unplug the charging cradle.
Do not keep this unit on the charger.
Attach the Charging Cradle
➀ Angle the NIGHTRAZOR
forward and place the tab from the
charging cradle over the rim of the
light.
➁ Tilt the
NIGHTRAZOR back
and gently snap into
place. The silver contacts
on the light will align
with the copper contacts
on the charging cradle.
Remove the Charging Cradle
➂ Place your thumb on the back part of the charging cradle
and gently but firmly tilt the NIGHTRAZOR forward with
your other hand.
Light Settings
► Adjusting the light – Off (1) is all the
way back (counter clock-wise) on the
intensity knob. Super bright (5) is all
the way forward (clock-wise). There
are clicks in between for low (2)
medium (3) and high (4).
► S-O-S flash – Turn the intensity knob
to low. Turn the intensity knob to
medium and back to low 3 times
quickly. The light flashes in the S-O-S
pattern. You can turn the intensity
knob to adjust the brightness, and
it will continue to flash. To stop the
S-O-S flash, turn the intensity knob
back to the off setting.
► Strobe flash – Turn the intensity
knob to super bright. Then turn the
intensity knob to high and back to
super bright 3 times quickly. You can
turn the intensity knob to the level
of brightness you prefer (at the low
setting, the light is steady). To turn it
off just turn the intensity knob to the
Off setting (1).
1
2
3
4
5
Battery Charging
► Always switch the NIGHTRAZOR
off before charging.
► Fully charge the NIGHTRAZOR
prior to using.
► In use – The NIGHTRAZOR will
make 4 short flashes every 60 seconds
to notify you of a low charge.
► At this point, you still have at least
12 minutes of charge left on the high
setting. To make the battery last longer
adjust the light to a lower setting.
Battery Life
The chart below shows the typical battery life for the NIGHTRAZOR.
Brightness Mode Normal –
Steady Light
Flashing –
S-O-S / Strobe
Low 48.0 hours 96.0 hours
Medium 16.0 hours 32.0 hours
High 7.3 hours 14.6 hours
Super Bright 2.8 hours 5.6 hours
1
2
1
2
3