CDA FWV900 - Manual (Page 9)

Reversing the door
It is possible to reverse the door on this appliance, if required.
To do so, follow the steps below:
1. Remove the stop mechanism (12) by unscrewing screws 11 and 13
2. With the door closed, remove the upper hinge pin cover, and then the upper and lower hinge pins. Support the door to
prevent it falling.
3. Remove the door carefully and place it on a padded surface to avoid the risk of damage.
4. Unscrew the four upper hinge plate screws on the right hand side and the blanking screws on the upper left hand side.
Remove the right upper hinge plate. Fit the left upper hinge plate, supplied with the instructions, using the four hinge
plate screws, and then fit the blanking screws on the right.
5. Unscrew the four lower hinge plate screws on the right hand side and the blanking screws on the lower left hand side.
Remove the right lower hinge plate and rotate the hinge plate 180˚. Refit the lower hinge plate on the lower left hand side
using the four hinge plate screws, and then fit the blanking screws on the right.
6. Rotate the door 180˚ and then relocate it on the upper and lower hinge plates. Refit both upper and lower hinge pins.
7. To level the door, adjust the upper and lower hinge plate screws and then tighten securely.
8. Reinstall the stop mechanism on the opposite side using screws 11 and 13.
Please note: Keep the spare upper hinge plate to be able to reverse the door back again.
Table of parts
1.
Screw
2. Decoration Plug
3. Top Hinge Pin
4. Right Top Hinge Plate
5. Glass Door
6. Left Top Hinge Plate
7. Lower Hinge Plate
8. Lower Hinge Pin
9. Screws
10. Cabinet
11. Screws
12. Stop Mechanism
13. Screws
14. Bottom Bracket
1
2
3