CDA FWV900 - Manual (Page 3)

Before first use
You must allow the appliance to settle for at least twenty four hours prior to switching the power on.
It is recommended that you remove all internal and external packaging and clean the interior of the appliance prior to first use,
using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior.
The appliance may have an odour to it at first use. This will disappear as the appliance cools.
Please note:
• The appliance will work continuously until it gets to the correct temperature.
• If the appliance is switched off, you should allow five minutes before switching it on again to prevent the risk of
unnecessary damage to the compressor.
• The LED display may not show the selected temperature whilst the appliance first gets to the correct temperature. This is
normal, and the display will be corrected automatically once the appliance has run for a few hours.
Use
• Only store wine in sealed containers
• Do not overload the cabinet
• Only open the door when necessary
• Do not cover the shelves with aluminium foil or anything else that will prevent air from circulating around the cabinet.
• To prevent damage to the door seal, ensure the door is fully open before removing the shelves.
• This appliance has been designed to work at an ambient temperature between 16º to 32ºC. Use of the appliance outside
of these parameters may cause the unit to fail.
• This is a self-defrosting appliance. The compressor will not run during the thirty minute defrost cycle.
• Do not pull the shelves beyond the anti-stop position (approximately one third out) when fully loaded.
• This appliance is intended to be used exclusively for the storage of wine.