Sound Anchors ADJ2 - Manual (Page 4)

4. After determining the location where you will be setting up your stands it is time to adjust
their level. With the stand in it’s operational position in the room place a magnetic torpedo
level vertically on the front face of the upright. Turn spikes so that the bubble is centered. Re-
peat procedure on side face of upright. Tighten jam nuts with a 9/16 wrench when the stand is
level.
5. Adjust the platform to the desired height and tilt. If you will be adjusting the tilt angle of
your speakers it is helpful to use a bubble protractor to ensure that each speaker is set up the
same when setting up the platform.
6. Remove the protective coating from both sides of the bluedots. Place one Bluedot on each
corner of the platform.
7. Place the speaker on the platform so that the front of the speaker extends over the front
edge of the platform.