Roadi RDT45 - Manual (Page 6)

CHECK
OWNER S MANUAL
,
OBD2 CODE READER
6
observed on the display. If you press "SCROLL" button, the "1. ENGINE"
message is observed again on the display.
LINKING
MENU: ---->
1. ENGINE
READY ?
YES NO…
ERROR!
NO CODES
If an ERROR! message shows up, turn the ignition off for about 10
seconds, check if the code reader’s OBDII connector is securely
connected to the vehicle’s DLC, and then turn the ignition back to on.
Repeat the procedure from step 5. If the “ERROR” message does
not go away, then there may be problems for the code reader to
communicate with the vehicle.
If you wish to ski p the Engine system, just press and release the SCROLL
button. When the display indicates "2.A/T", you may choose to read this
system by pressing and releasing the ENTER button or ski p to the next
systems: SRS or ABS(Airbag System) by choosing the SCROLL button.
6. Read the Diagnostic Trouble Codes on the LCD display.
If there are no Diagnostic Trouble Codes present, the display will read “NO
CODES”.
If more than one Diagnostic Trouble Code is present, the first code
number will display on the first line of the LCD display, the numerical
sequence of the code and the total number of the codes present in the
system will appear on the second line. To view additional codes, press and
release the ENTER”button to scroll, as necessary, until all the codes have
been shown up.