RearviewSafety RVS-091406 - Manual (Page 13)

13
Reverse With Confidence ™
Pairing & Connecting
Figure 1 Figure 2
Pairing is not necessary as the unit has already been paired.
If you are not able to connect the camera, please try to pair the
camera by the following steps:
1. Press “Pair” button See page 9, Diagram B) on the Wireless
Digital Transmitter. You will see the LED Blinking in RED/BLUE.
The unit will remain in Pair mode for 15 seconds
2. Go to the monitor and do the following step:
a. Press “MENU”
b. Go to camera settings, push menu again to start pairing
sequence. (Below Figure 1)
c. The unit is now in pair mode - if the unit was able to
search and connect with the camera, the display will show
“Pair OK”. (If you see “Timed Out”, please repeat all steps.)
d. Press and hold “MENU” button on rear of monitor (see
page 9, Diagram A) until picture appears.
3. Distance Grid: select grid line on/off.