RearviewSafety RVS-091406 - Manual (Page 11)

11
Reverse With Confidence ™
Installation Guide
6. While sitting in the driver’s seat of the car with the key in
the ignition position. The monitor will automatically start
when vehicle is put in reverse. If when you place the vehicle
in reverse there is no image, you may need to pair the
camera with the monitor. (see page 13)
7. Put the vehicle in reverse. If you have a clear picture, put
the vehicle back in park and turn the key to the off position.
You are now ready for final step.
8. Take the Wireless Transmitter and using the double sided 3M
Sticker attach the box to the inside of your car.
9. Replace the light socket back into the reverse light housing.
10. Replace any interior panels that may have been removed to
access the taillight and close your trunk or rear hatch.
1. Power ON/OFF
• The Dash Monitor will automatically turn ON when it is
connected to a power source, and the camera is receiving
power.
2. Rearview Image
• Rearview image will automatically appear on the screen
during reverse and will remain in standby when the vehicle
is in any other gear.