PulseTech XCR-20 Battery Recovery Charger & Desulfator (100X500) - Manual (Page 3)

3 800-580-7554
IMPORTANT SAFETY INSTRUCTIONS
■
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for your Xtreme Charge
HD Recovery Charger.
Use of an attachment not recommended or sold by PulseTech Products may result in a risk
of fire, electric shock, or injury to persons.
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If extension cord must be
used, make sure:
• Pins on plug of extension cord are the same number, size and shape as those of plug
on charger
• Extension cord is properly wired and in good electrical condition
• Wire size is large enough for ac ampere rating of the charger as specified:
Do not operate charger with damaged cord or plug - replace the cord or plug immediately.
Do not operate charger if it has received a sharp blow, been dropped or otherwise damaged
in any way; take it to a qualified serviceman.
Do not disassemble charger; take it to a qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of electrical shock or fire.
To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
■
WARNING! - RISK OF EXPLOSIVE GASES.
WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE
EXPLOSIVE GASSES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF
UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS
MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
Length Wire Gauge
25ft. 16 AWG
50 ft. 12 AWG
100 ft. 10 AWG
ALL EXTENSION CORDS
MUST BE UL RATED
Caution: risk of danger