Pro-Tools Large Radius Bender - Manual (Page 2)

3 ROLL BENDER
OPERATING INSTRUCTIONS
STEP 1
MARK THE MATERIAL IN THE MIDDLE
STEP 2
LINE UP THE CENTER OF THE MATERIAL WITH TOP
ROLLER THEN TIGHEN 1/2 TURN.
STEP 3
ROLL THE MATERIAL COMPLETELY TO THE RIGHT.
STEP 4
ROLL THE MATERIAL COMPLETELY TO THE LEFT..
STEP 5
RETURN THE MATERIAL TO THE MIDDLE –TIGHEN THE
TOP ROLLER 1/2 TURN. REPEAT THE PROCESS UNTIL
DESIRED BEND.
IMPORTANT!! WHEN USING THIS TYPE OF BENDER, IT WILL LEAVE A STRAIGHT PIECE
ON EACH END. (THESE ARE CALLED TAILS & WILL NEED TO BE CUT OFF.)