ProTemp PT-47-TTC - Manual (Page 12)

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A FUEL SOURCE
© 2013, Pinnacle Products International, Inc. Propane Tank Top Heater User’s Manual
®
11
Troubleshooting Guide
/RFDWLQJYour serial number can be found in the bottom left hand corner of the heater’s instruction hang-tag.
,WZLOOEHJLQZLWKWKHOHWWHUV³+77´IROORZHGE\GLJLWV)RU([DPSOH+77+DYH\RXU6HULDO
Number ready before calling customer service at 800-641-6996.
Problem Possible Cause(s) Solution
Unit will not light.
1. Valve on propane cylinder
closed.
2. Propane cylinder empty.
3. Regulator not in (HI) position.
4. Defective regulator
1. Open cylinder valve by turning
COUNTERCLOCKWISE.
2.
5H¿OOF\OLQGHU
3. Turn regulator to (HI) position.
4. Replace regulator assembly.
Burner will not stay lit
when gas valve plunger
is released
1. Tip switch activated or
defective.
2. Wire terminal connections
unplugged.
3. Defective thermocouple.
4. Defective MPU.
1. Place heater in upright position
or replace tip switch.
2. Check wiring connections.
3. Replace thermocouple.
4. Replace MPU.
([FHVVLYHÀDPHVFRPLQJ
out of burner, not glowing
UHG)ODPHVÀDVKEDFN
/ burn inside the mixing
tube.
1. Air inlet holes blocked or
covered.
2. Burner screen damaged.
3. Gap between burner screen
and burner can.
1. Clear obstructions from
2. Replace Burner screen.
3. Replace or repair burner head
assembly.