Pro-Ject Audio Systems Set iPod® goes digital - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject iPod goes digital-Set · Revision 2013.1.15
3
Connecting amplifier and speakers
The output terminals accept loudspeaker cables terminated with 4mm  Banana plugs, spades connectors
or naked wire.
Connect the cable terminals on the amplifier to the terminals on the speakers.
!
The red speaker terminals carry the positive signal (+), the black speaker terminals the negative
signal (–). Make sure the polarity of the connection is correct at each end of the cables.
Only connect one loudspeaker with an impedance not less than 4 ohms per channel.
Record output, connecting a headphone amplifier - Stereo Box S
Record Out connects an analogue record device ore a Pro-Ject Head Box headphone amplifier.
Record Out provides a fixed output level.
Connectors - Dock Box S Digital
Pro-Ject Audio Systems, Vienna, Austria
!
Make all connections whilst the Dock Box is disconnected from the power supply.
Connection to an integrate, pre, power amplifier or active speakers
Connect the Left/Right Out socket to a high level input on your integrated or pre amplifier, the pre input on
your power amplifier or active speakers.
!
Connected to devices with a volume control, the volume level of the Dock Box has to be set to max..
Turn the Dock Box volume level to minimum before switching on your power amplifier or active speakers.
Connection to a external D/A-converter
Connect the S/PDIF Co-axial out socket to a coaxial digital input on the D/A converter or AV processor.
Doing so allows you to use the signal in its digital for further digital processing.
Connection to a TV-set or a beamer
Connect the S-VIDEO socket to a s-video input of your TV-set or beamer.
„All digital“ units, such as iPhone 5 ® , do not support the s-video output.
Fitting and adjustment of the iPod ® /iPhone ® cradle
Use the knurled screw supplied to fix the cradle to the Dock Box chassis. Do not fully tighten the screw yet.
Now place your iPod
® /iPhone ® on the Dock Box contacts. Move the cradle so that it supports the
iPod ® /iPhone ® and tighten the screw.
This device is suitable for iPods ® /iPhones ® with 30-pole connector only.
To connect units with a lightning-connector, such as iPhone ® 5 or iPod ® Touch 5, a lightning-adapter
(lightning connector  30-pole connector) is needed.
!
Use without the cradle will eventually break the 30-pole connector of the Dock Box and the socket of
the iPod
® /iPhone ® Before connecting the iPod ® /iPhone ® any sort of cover has to be removed.