Service, Technical specifications pro-ject phono box e, Potential incorrect use and fault conditions – Pro-Ject Audio Systems Phono Box E User Manual

Page 3: Warranty, Copyright

Technical specifications Pro-Ject Phono Box E

* typical for MM or high output MC cartridges
Input capacitance/input impedance, MM: 47kohms/120pF

Gain:

40dB

Output voltage typically:

500mV/1kHz at 5mV/1kHz

Noise floor:

88dB (A weighted)

THD:

<0,05%

RIAA-equalisation curve accuracy:

20Hz - 20kHz / max. 0,5dB

Input:

1 pair RCA/phono sockets

Line-level output:

1 pair RCA/phono sockets

Outboard power supply:

18V/500mA DC

Power consumption:

20mA DC

Dimensions W x H x D (D with sockets):

120 x 32 x 100 (106)mm

Weight:

269g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between player and phono amplifier or amplifier. This could be due to a faulty plug,

broken wire or solder joint or simply loose plug/socket connection.

Strong hum:

No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Pro-Ject Audio Systems is a Registered Trademark of H.
Lichtenegger.

This guide was produced by: Pro-Ject Audio Systems
Copyright

The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.