Important notice – Pro-Ject Audio Systems Phono Box E User Manual

Page 2

Dear music lover,

thank you for purchasing a Pro-Ject Audio Systems phono amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily

accessible at all times.

Never handle the device, the power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Connectors

Make all connections whilst the phono amplifier is disconnected from the power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the
left channel black or white.
Do not connect the phono amplifiers output to a phono input (sometimes labelled gram, disc or RIAA)
on the amplifier.
Never use any other power supply than the one supplied with the unit.

Connecting the record player (MM or high output MC cartridges only)

Connect the tone arm signal lead to the input (In) of the phono amplifier. The earthing wire (GND) may be

connected to the screw terminal if you encounter hum problems when using the record player.

Connection to the amplifier

Connect the output (Out) of the phono amplifier to a line input (such as AUX, CD, Tuner, Tape or Video) on
your amplifier.

Mains power connection

The phono amplifier is supplied with a power supply suitable for your countries mains supply. Check the label
before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug

from the power supply to the Power 18V DC socket of the phono amplifier before connecting the power
supply to the mains.