Pro-Ject Audio Systems CD Box S User Manual

Page 5

Replacing batteries

Proceed as follows:

 Unlock and slide open the battery case cover

 Replace the battery.

Make sure the battery is the right way round !

 Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject CD Box S

Supports:

CD, CD-R, CD-RW and Hybrid-SACD

Frequency response:

20Hz - 20kHz/-0,3dB

Noise floor:

96dBA

THD: 0,01%
Line-level output:

1 pair RCA/phono sockets

Output voltage:

1Vrms

Digital output:

1 x co-axial (S/PDIF)

D/A converter:

Texas Instruments TLV320DAC23

24Bit/96kHz, 8-times oversampling

Outboard power supply:

9V/2.000mA DC; suitable for your country's mains supply

Power consumption:

300 - 1.500mA DC, <1W in standby

Replacement battery remote control:

1 x CR2032 / 3V or 1 x CR2025 / 3V

Dimensions W x H x D (D with sockets): 206 x 36 x 150 (156)mm
Weight:

1.260g without power supply

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to
press. The manufacturer reserves the right to make

changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.