Cortelco CALLER ID TYPE II 2700 - Manual (Page 8)

8
I
NSTALLATION
DESK MOUNT
1. Select the desired viewing angle and install the desk stand. The
desk stand can be installed in two positions to give a choice of
viewing angle.
2. Connect the power adapter. The power adapter connects to the
jack marked DC 9V on the bottom of the phone. Plug the large
part of the adapter into the wall outlet. Use only a 9V DC. 200mA
or 300mA, center positive Class 2 adapter.
3. Connect the line cord. The line cord conncects to the jack marked
LINE on the bottom of the phone..
4. Plug the coiled cord into the handset jack, and then plug the other
end of the cord into the base.
5. Place the handset on the base.
WALL MOUNT
1. Remove the desk stand. The unit will then mount directly on a
standard wall telephone jack.
2. Connect the power adapter and the line cord. See Steps 2 and 3
above.
3. Rotate the handset hook into the wall mount position.
4. Plug the coiled cord into the handset, and then plug the other end
of the cord into the base.
5. Place the handset on the base.
ANSWERING MACHINE
1. Connect the LINE jack of the answering machine to the wall
telephone jack.
2. Connect the LINE jack of the model 2700 phone unit to the PHONE
jack of the answering machine.
3. Set the answering machine to answer after 2 or more rings.
MESSAGE WAITING LAMP
If your phone is installed behind a Message Waiting enabled PBX, you
will need to set the M/W switch in order to receive Message Waiting
indication.
1. Locate the switch on the bottom of the telephone.
2. For 90V PBX Message Waiting Indication, move the switch to the
position marked “90V”. For 24V PBX Message Waiting Indication,
move the switch to the position marked “24V”. If connecting
directly to telephone lines, move the switch to the center “OFF”
position.