Cortelco CALLER ID TYPE II 2700 User Manual
Page 10

10
U
NIT
S
ETUP
FACTORY PRESETS
The following table shows the default factory settings:
Display
Setting
LANGUAGE .............................................................................. English
STUTTER TONE ............................................................................. No
AREA CODE ....................................................................... No Setting
LDS CODE ........................................................................................ 1
TIME & DATE ...................................................................... No Setting
FLASH TIMER .......................................................................... 600 ms
RINGER CADENCE .......................................................................... 3
RINGER VOLUME ............................................................................. 5
VOICEMAIL NUMBER ......................................................... No Setting
#3 SEC PAUSES ................................................................. No Setting
VM PASSWORD .................................................................. No Setting
HOLD MODE ........................................................................ NORMAL
RELEASE MODE ............................................................... NEW CALL
Note: After the unit has been completely configured for the first time, use MENU to
review or reprogram the features.
After the adapter is connected, the display will show as indicated
below for setting.
1. [SELECT LANGUAGE] appears on the display. Press REVIEW UP to
select the language. ENG - English, ESP - Spanish, FRE - French,
and then press MENU to confirm the selection.
2.
When [STUTTER TONE] appears, the default setting is “YES”. To
toggle stutter tone, press 1 for Yes or 2 for No. Press MENU to
confirm selection.
3.
When [ENTER AREA CODE] appears, enter the desired area code
using the keypad. Use REVIEW UP and REVIEW DOWN to skip
a digit. Press MENU to confirm area code. Follow the same
procedure for both area code settings. To leave an area code
blank, press MENU without entering digits.
4.
When [SET LDS CODE] appears, enter the desired LDS code using
the keypad. Press MENU to confirm the selection.
5.
When [EDIT TIME & DATE] appears, enter the time using the
keypad. If the time is AM, press REVIEW UP since this is the
default value. If the time is PM, press REVIEW DOWN and then
press REVIEW UP. Press MENU to confirm the settings.Example:
To enter 8:35 AM, enter 0835 and then press REVIEW UP to skip
to the date because the time is AM by default.