CDA RC 9020 - Manual (Page 4)

4
Introduction
Congratulations on your purchase of this CDA cooker which has been carefully
designed and produced to give you many years of satisfactory use.
Before using this appliance it is essential that the following instructions are carefully
read and fully understood.
We would emphasise that the installation section must be fully complied with for your
safety to ensure that you obtain the maximum benefits from your appliance.
Fig. 1
Assembling the
backguard
■ Remove the two spacers
“A” and the screw “B”
from the rear of the cook-
top.
■ Assemble the backguard
as shown in figure 1 and
fix it by screwing the cen-
tral screw “B” and the
spacers “A”.
Declaration of
CE
conformity
✓ This cooker has been designed, constructed and marketed in compliance with:
- Safety requirements of EU Directive "Gas" 90/396/EEC;
- Safety requirements of EU Directive "Low Voltage" 2006/95/EC;
- Protection requirements of EU Directive "EMC" 89/336/EEC;
- Requirements of EU Directive 93/68/EEC.
A
B
GB